Price of vertical turning grinding compound machine tool

Price of vertical turning grinding compound machine tool

Which of the following aspects do CNC vertical lathes need to be used

1、 Carefully implement the relevant provisions of the general operating procedures for metal cutting machine tools.

2、 Carefully implement the following general regulations on vertical vehicle:

（1） In the work, we should conscientiously:

1. The rough surface of the workpiece shall not be directly placed on the worktable, but shall be supported by sizing block or screw top; It is forbidden to use the worktable for other operations, such as hammering to correct workpieces, welding workpieces, etc.

2. When aligning the workpiece, only jog the worktable to rotate and align at low speed, and do not align at high speed.

3. When starting and stopping the workbench, the starting and stopping handle of the workbench can only be pulled by hand, and pedaling is strictly prohibited.

4. When the worktable rotates, it is not allowed to do beam lifting and rapid movement of tool rest.

5. When moving the beam, loosen the clamping device first, and clamp it immediately after moving. After the beam is lowered each time, it should be raised a little to eliminate the clearance between lead screws and nuts.

6. Gravity cutting is not allowed when the ram of vertical tool holder and side tool holder extends for a long time; When machining with vertical tool holder, especially for gravity cutting, the pillars should be lowered to the position close to the work as far as possible.

7. During intermittent cutting, the feed rate and table speed shall be appropriately reduced.

8. When changing speed, the control lever must be pushed to the specified position. If the gear is not meshed well, it shall be adjusted by inching after work. It is not allowed to forcibly pull the "start stop" handle of the worker's table.

（2） After operation, for machine tools with two vertical tool holders, stop the vertical tool holder symmetrically to both ends of the beam; For machine tools with a vertical tool rest, stop the vertical tool rest in the middle of the beam; The side cutter holder shall be moved to the lowest position of the column.

Dalian Fenghua CNC Machine Tool Manufacturing Co., Ltd. is a professional machine tool equipment manufacturer specializing in CNC vertical lathe, Dalian single column double lifting vertical lathe, Dalian double column CNC vertical lathe and Dalian high-speed CNC lathe. Friends from all walks of life are welcome to negotiate and consult!