About Dalian high-speed CNC vertical lathe, I share with you the salient points and tool holders of CNC vertical lathe

1、 About Dalian high-speed CNC vertical lathe, I share with you the salient points and tool holders of CNC vertical lathe

Compared with ordinary vertical lathes, the outstanding advantage of CNC vertical lathe is that it adopts display screen operation, and only needs programming. In this way, it can greatly simplify the operation, make the operation more simple, and improve the work efficiency.

In CNC vertical lathe, the tool holder is not divided into front and rear, which is generally on the right side of the spindle center. In addition, it generally has two, one is the vertical tool rest, and the other is the side tool rest.

The vertical lathe shall be used frequently and shall not be idle or sealed for a long time, which is very bad for the equipment and may damage the equipment. The electric control device should avoid the entry of dust, dust, etc. otherwise, the insulation performance between electrical components may be reduced or even damaged.

The ventilation and heat dissipation system in the electric control cabinet shall be cleaned regularly to ensure its normal function. If there are two vertical tool holders on the equipment, they should be stopped symmetrically at both ends of the beam after the work.

2、 Usable structure of NC vertical lathe

On the vertical lathe, there is a kind of NC vertical lathe, and at present, this kind of vertical lathe is widely used. Therefore, based on this point, what is the usable structure of NC vertical lathe?

Vertical lathe is the abbreviation of vertical lathe. Therefore, we should have a correct understanding on this point and can't make mistakes. For the operation and use of this equipment, the specific aspects that should be paid attention to are to start the work for the equipment and how to use the automatic knife walking, so as to ensure the use effect of the vertical car.

CNC vertical lathe, which can also be called CNC vertical lathe. Therefore, these two names refer to the same vertical lathe, but the names are different. As for the vertical lathe, M6 in the lathe program refers to the tool change action performed by the tool magazine, that is, the tool exchange.

There is no fixed tool setting point in the trial cutting and tool setting of NC vertical lathe. Moreover, in this kind of vertical lathe, the tool setting principle is the same, but the operation of different CNC systems will be different. Therefore, it is recommended to read the equipment operation manual before operation to avoid errors.